Jio phone f50y flash file

Jio phone F50Y came with qualcomm chip-set and run on firefox KAI OS.the Jio phone F50Y has 2.4 inches of screen with 240 x 320 pixels resolution. Supports true VoLTE with video call features. Powered by Dual core processer with clocked speed is 1 GHz speed and Cortex A7 GPU. Support single nano Jio SIM card, you cannot used any othe sim like Vodafone, Airtel or any other. Battery capacity F50Y is 2000 mAh and camera capacity, rear camera is 2 megapixel also front camera is 0.3 mega pixel. Jio phone F50Y memory capacity are internal storage 4GB, 512 MB of RAM, you can expandable with 128 GB of memory card. In jio phone F50Y installed Jio TV, Jio Chat, Jio Cinema, Jio TV and more. Support 24 Indian language also support Jio voice command.

Jio phone f50y flash file: Here I can share the official F50Y flash file with flashing tutorial. so lets start.

Step 1: Charged the F50Y battery with 30%, if you have less than 30% please charged the battery 30% and need a micro USB cable.

Step 2: Before flashing you need to installed driver. Download the driver for Jio phone F50Y.  Click here to download Jio phone F50Y driver (1 download)

Step 2.1: Now extract the file (if you unable to extract please download WinRar).

Step 2.2: Open the extract folder then double click on setup file. Accept the licence agreement, click Next bottom for next step.

Step 2.3: Click on Install.

Step 2.4: Click again on Next bottom.

Step 2.5: Tick on Always trust software from “QUALCUMM incorporated”. Maybe you need to click 4-5 times on Install bottom,

Step 2.6: Tick on WWAN-DHCP is not use to get IPAddress then click on next and finish the install processed and restart the computer.

Step 3: You need to download F50Y flashing tool  Click here to download F50Y flashing tool (1 download) and F50Y flashing file  F50Y flash file (0 downloads) . Extract the both file and put on C drive on your computer.

Step 4: now remove the battery from your Phone and again insert the battery then you need to press Up pad key + down pad key + power bottom for boot mode of Jio phone F50Y. Insert the USB cable into phone.

Step 5 : Check port to right click on My Computer > Click on properties > click device manege > click on port then show ports which port connect from phone  (It’s not compulsory, If u unable to connect phone to computer then you checked this port for driver successfully installed or not, if driver not installed please reinstall and restart the computer). Open the MegaFone folder then double click on MegafoneSWDownload.

Now open megaFone, Tick on reboot, click searchPath and select the prog_emmc_firehose_8909_ddr.mbn file. Then click to download. needed 5 to 10 minute for full flash. please follow the image bellow.

Please don’t remove the battery and wait few minutes. Automatically restart Jio phone F50Y after flash done. Now ready for use your Jio Phone F50Y. Enjoy.

 

Leave a Reply

Your email address will not be published. Required fields are marked *